T
Hi everybody,
I have replaced a faulty S5-95U 8MC01 (with 2 serial ports) with S5-95U 8MA04. There was an OP7 connected on the second serial port, and since 8MA04 doesn't have a second serial port I have connected the OP7 to the PG port of 8MA04. The system doesn't.
My questions:
1. Is it possible to replace 8MC01 with 8MA04 if only one serial port is being used.
2. How do I configure PLC/OP?
3. What problems I might encounter? (Note: I have a PG720 to do programming)
4. Is it safe to do so?
I would appreciate if anyone could be of any help.
Thanks,
bagi
I have replaced a faulty S5-95U 8MC01 (with 2 serial ports) with S5-95U 8MA04. There was an OP7 connected on the second serial port, and since 8MA04 doesn't have a second serial port I have connected the OP7 to the PG port of 8MA04. The system doesn't.
My questions:
1. Is it possible to replace 8MC01 with 8MA04 if only one serial port is being used.
2. How do I configure PLC/OP?
3. What problems I might encounter? (Note: I have a PG720 to do programming)
4. Is it safe to do so?
I would appreciate if anyone could be of any help.
Thanks,
bagi