K
Hi all,
First post here and I am sitting with a bit of a problem.
I need to program my CPU222 using Wonderware Incontrol.
I only have the USB / PPI Multimaster Cable (6ES7 901-3DB30-0XA0).
So far I have not had much luck doing this as most guides assume you have the ethernet module for the PLC.
Any advice would be greatly appreciated.
Thanks in advance
First post here and I am sitting with a bit of a problem.
I need to program my CPU222 using Wonderware Incontrol.
I only have the USB / PPI Multimaster Cable (6ES7 901-3DB30-0XA0).
So far I have not had much luck doing this as most guides assume you have the ethernet module for the PLC.
Any advice would be greatly appreciated.
Thanks in advance