SCADA communication with Yokogawa UT35A controller

I

Thread Starter

instrumentation

hello

I am using Yokogawa UT35A controller to control my process but this controller is having a facility of RS 485 communication. Now i want to use this facility of this controller to have a view of the process on SCADA. could to suggest?

Regards
Viranjay rai
 
The 3rd digit in the model number defines which comm protocol/transport layer your 35A has.
none, 485, Ethernet, CC-Link, Profibus-DP or DeviceNet. The later 3 apparently come with Modbus master as well.

Find out if your SCADA has a driver for the protocol/transport layer that your controller has.

Then get the comm manual for the SCADA and the UT35A and start reading about how to make a connection.
 
Top