Control

SCADA Integrity Cycles

  • Thread starter Roberto A. Ricardi
  • Start date
R

Thread Starter

Roberto A. Ricardi

Dear groups members,

I'm a hardware manager, have a electrical control center with about 50 utr's working in DNP 3.0 protocol. All the digital and analog points are
treated like events, and we use a periodic global static cycle as usually. I need to know where ( IEC 870 ?) can I find the best relation to fi the global static cycle period.

Thanks in advance for your attention.

Roberto A. Ricardi
SACME S.A.
Buenos Aires, Argentina
[email protected]
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
W What makes SCADA and DCS different? Are they always integrated? If yes then how? Distributed Control Systems - DCS 5
E Abb scada udw error inserter Programmable Logic Controller - PLC 2
H What is the purpose of the HMI/Scada Tag - how come rockwell scada does not need it and use a single point of truth? Human Machine Interface - HMI 0
R Citect SCADA 7.2 Indirect Tag Reference General Software Chat 0
K Wind Turbine SCADA cabinet delay for single GE turbine Human Machine Interface - HMI 0
Similar threads
What makes SCADA and DCS different? Are they always integrated? If yes then how?
Abb scada udw error inserter
What is the purpose of the HMI/Scada Tag - how come rockwell scada does not need it and use a single point of truth?
Citect SCADA 7.2 Indirect Tag Reference
Wind Turbine SCADA cabinet delay for single GE turbine

You May Also Like

Top