C
Hello everybody.
Somebody have experienced or any idea with SCADA Real-flex based on PC
and process several protocols at the same time (threads or parallel
tasks) outgoing by each serial port three protocols three different
ports. The protocols discussed are DNP 3.0, Sangamo Command Set (this is
by Schlumberger) and Modbus maybe using additional serial cards inside
hardware of QNX or several serial ports inside PC.
Any ideas will be appreciate
Thanks
Cuitlahuac.
Somebody have experienced or any idea with SCADA Real-flex based on PC
and process several protocols at the same time (threads or parallel
tasks) outgoing by each serial port three protocols three different
ports. The protocols discussed are DNP 3.0, Sangamo Command Set (this is
by Schlumberger) and Modbus maybe using additional serial cards inside
hardware of QNX or several serial ports inside PC.
Any ideas will be appreciate
Thanks
Cuitlahuac.