SCADAPACK VS ZOID

J

Thread Starter

JYM

Did anyone ever tried matching a Control Microsystem ScadaPack with a KEP Zoid. The ZOID is a model ZOIDDCMODL ver 47.00D. Both of them should be talking Modbus RTU's protocol but I cannot get them to talk to each other. Any hint?

JYM
 
Suggest you invest in a Modbus utility program like Mdbus ( "www.calta.com":http://www.calta.com ). It is a great utility for debugging Modbus communications. Use it as a modbus master to verify the com port on the ScadaPack is working properly. If everything checks out OK there then switch it over to it's slave emulation mode and check the Zoid messages for proper syntax. Good luck!

Doug Eves
[email protected]
 
Top