D
i am currently using a PLC that only uses sensors that use the 2-wire protocol. however i would like to use a normal sensor. is there any way i can convert it.
Thread starter | Similar threads | Forum | Replies | Date |
---|---|---|---|---|
M | Oil Debris Sensor | Sensors & Calibration | 0 | |
K | MARK V ALARM (SEISMIC VIBRATION SENSOR IS DISABLED) | Power Generation | 3 | |
E | Water level sensor | Sensors & Calibration | 3 | |
M | Integrating 2-wire Rpm sensor to current 3-wire Rpm sensor system | Sensors & Calibration | 3 | |
H | Sensor accessories | Instrumentation & Measurement | 2 |