Control

Setting up Profinet I/O in Siemens TIA Portal

O

Thread Starter

oli268

I have a Lenze servo controlled by an Inverter Drive 8400 TopLine C. I have profinet communication between the Inverter and a Siemens S7-1500 PLC. I don't know how to setup/view the Profinet IO using the Siemens TIA Portal V13.
 
S

Steve Myres

The general procedure for third-party slave devices is to download from the manufacturer the configuration file and add it to your equipment catalog. Then it's just a matter of dragging it into your network diagram like native Siemens components. If there are a number of optional I/O configurations, which there often are, that will be configured by dragging virtual I/O modules (corresponding to the available configurations or portions thereof) onto the device. Or sometimes configuring in the config pages at the bottom of the hardware window. If so, these should appear in the hardware catalog as well, often in a different subfolder. You also must configure the IW/QW starting points, obviously.
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
S Mark VIe Ramp Rate Constant Setting for Real Power (MW) General Automation Chat 1
D Setting up a VFD to unknown motor General Automation Chat 6
T ABB ACS 800 Drive Overload setting and Over current limit setting. Electrical Engineering 10
S Question: Modbus Plus 32 Bit Word Order Read/Write Driver Setting Modbus 1
T MkV SDCCG4A Jumper JP23 Setting Power Generation 7
Similar threads
Mark VIe Ramp Rate Constant Setting for Real Power (MW)
Setting up a VFD to unknown motor
ABB ACS 800 Drive Overload setting and Over current limit setting.
Question: Modbus Plus 32 Bit Word Order Read/Write Driver Setting
MkV SDCCG4A Jumper JP23 Setting

You May Also Like

Top