Signal Conversion

P

Thread Starter

Phil M.

Hi all,
I have a linear transducer that is supplied with
+5 volts and -5 volts. Therefore it's signal is variable between +5 & -5 depending upon extension.
(Its a position sensor for a hydraulic cylinder)
I would like to be able to convert this signal into a 0 to 5 volts DC or 0 to 10 volts DC signal
to match a new controller setup I am experimenting
with. I seem to remember there being an op amp circuit soloution but I'm damned if I can find it.
Any help appreciated.
Thanks
 
Hi,
There is a solution of using one S7-200 controller with one analogue module to carry your
request.
Regards
 
Top