Control

SINEC L2 and PC Control

C

Thread Starter

Christophe

Hi,

I'm looking for a PC board that can drive a SIEMENS SINEC-L2 with ET200U stations. Does anyone has a solution?
 
K

Konni

Hi,

SINEC-L2 was renamed to PROFIBUS after it becomes an open standard. Just use a Profibus card from Softing, Hilscher, Siemens or other to talk to your device.

Best regards,
Konni
[email protected]
 
A

Armin Steinhoff

SIEMENS SINEC-L2 has been replaced by PROFIBUS-DP years ago.

For MS-Windows, QNX4 and QNX6 are PROFIBUS-DP master boards (ISA, PCI, PC/104) available from
e.g. Softing.

Regards

Armin Steinhoff
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
A SINEC H1 to Ethernet (RJ45) General Communications Chat 3
C Sinec H1 protocol Human Machine Interface - HMI 2
A network interface card Sinec L1 Networking 14
V PROFIBUS AND SINEC L2 General Communications Chat 1
J Sinec L1 Networking 4
Similar threads
SINEC H1 to Ethernet (RJ45)
Sinec H1 protocol
network interface card Sinec L1
PROFIBUS AND SINEC L2
Sinec L1

You May Also Like

Top