Control

Smar OPC Communication LC700 v8

A

Thread Starter

ABorgogni

I have some trouble with OPC Server LC 700 v8, connected in Ethernet mode to redundant LC700 D3-R System.

I'm using two OPC Client connected with this server at the same time, the first Client request about 200 Boolean and 100 Real Tag,
the second one about 150 Boolean and 50 Real Tag.

The Server Scan Time is very slow about 10 second when both clients are connected, this time is reduced to 5 second when only one client is connected.

I have already try to reduce the Scan Time over the TagList v8 software but without any result.

How is possible to reduce the Scan Time or improve Server performance?

Best regards
 
A

A.Borgogni

This problem was solved by increasing from 4ms to 40ms the Duty Off time on the CPU comm parameters.

A.Borgogni
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
S Rockwell PLC OPC UA Server to Siemens OPC DA Server Communication possible Open Platform Communications (OPC) 1
S Matrikon OPC support Fanuc CNCs supports communications with multiple protocol networks, including Fanuc Focas 1 Ethernet and Fanuc Focas HSSB Open Platform Communications (OPC) 0
R Integrating a SMAR HI302-I and a DC302 to a Foundation Fieldbus Network Networking 0
D HART-communication: smar HT2015 input-filter problems General Automation Chat 0
H Use of VFD's with SMAR IF302 General Automation Chat 1
Similar threads
Rockwell PLC OPC UA Server to Siemens OPC DA Server Communication possible
Matrikon OPC support Fanuc CNCs supports communications with multiple protocol networks, including Fanuc Focas 1 Ethernet and Fanuc Focas HSSB
Integrating a SMAR HI302-I and a DC302 to a Foundation Fieldbus Network
HART-communication: smar HT2015 input-filter problems
Use of VFD's with SMAR IF302

You May Also Like

Top