Control

SPI Protocol

M

Thread Starter

Matt Van Dyke

I have to configure a slave for an SPI Protocal Master. I'm using a 5/03 and am configuring a dryer. I have read some of the AB publications but need some actual experience advice. Are there specific address locations to place the required SPI Protocal information in the 5/03? The 1771-SPI card resides in a PLC-5 and is the Master. Will I need to block transfer the data in the 5/03 ?

Thanks for the help

Sincerely
Matt
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
R SPI (Smart Plant Instrumentation) Alternatives General Software Chat 0
H Query a Dryer using SPI communition port Programmable Logic Controller - PLC 0
A SPI protocol for Secure digital card General Communications Chat 0
H Looking for Modbus with SPI protocol Modbus 3
K SPI Protocol General Communications Chat 2
Similar threads
SPI (Smart Plant Instrumentation) Alternatives
Query a Dryer using SPI communition port
SPI protocol for Secure digital card
Looking for Modbus with SPI protocol
SPI Protocol

You May Also Like

Top