Control

Stepper motor pulse width

A

Thread Starter

Anonymous

I want to send pulse of 10ms from PLC to my stepper driver. Is it possible to drive the stepper by using this range of pulse? Does the driver accept this range of pulse?
 
R

Robert Scott

10 msec. is plenty long enough for any stepper translator module. When you say "stepper driver" do you mean a stepper translator, which accepts step pulses and direction input and translates them into the actual A and B phases for the motor? On the other hand, if your stepper driver is just an amplifier, then your PLC needs to provide a sequence of A and B states to the driver and not just a pulse.

Robert Scott
Real-Time Specialties
Embedded Systems Consulting
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
rockybhai Increase RPM of NEMA34 86HS9860A4 1.8 degree 6amp stepper motor Motion Control 3
annlee Looking for a Trap Door + Stepper motor with homing capabilities compatible with RPI General Automation Chat 2
G Beckhoff KL2541 Stepper Motor Lock Setting Motion Control 0
M Stepper motor demagnetization Motion Control 8
S stepper motor and RC Motion Control 14
Similar threads
Increase RPM of NEMA34 86HS9860A4 1.8 degree 6amp stepper motor
Looking for a Trap Door + Stepper motor with homing capabilities compatible with RPI
Beckhoff KL2541 Stepper Motor Lock Setting
Stepper motor demagnetization
stepper motor and RC

You May Also Like

Top