Control

STL not set

C

Thread Starter

cmens

AN T10
L S5T#5S
SD T11

A T11
L S5T#5S
SD T10

A T10
S M100.0

What is the exact reason for M100.0 not getting set?

Is this "mystery" related to scan cycle versus time resolution (time base) of the S5 timers?

When the last two statements are shifted to the top of the codes, M100.0 gets set !

Regards
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
M S5 STL Program conversion to Ladder Programmable Logic Controller - PLC 1
A function call stl -> lad Languages 4
K S7 STL indirect addressing Programmable Logic Controller - PLC 3
K Simatic S5 STL Commands Programmable Logic Controller - PLC 3
A stl instruction set Programmable Logic Controller - PLC 4
Similar threads
S5 STL Program conversion to Ladder
function call stl -> lad
S7 STL indirect addressing
Simatic S5 STL Commands
stl instruction set

You May Also Like

Top