D
Hello to everyone on the forum,
we have a customer with an old TMQ TSX 67 40 PLC with the P67 425 processor. The configuration also includes 9 AXIS modules of the type TSX
AXM 162 (single-axis control). The controller was put into operation in 1995/6.
We need, for diagnostic reasons, to upload the program, but don't have either the software or the connection cables (and/or PCI cards)
necessary. Would you be so kind to help us with the following:
1) what is the software needed for uploading and monitoring of the program from this type of PLC (including monitoring of the AXIS modules)?
2) what is the hardware (the cable, and/or the PCI card) for connecting a PC (with the above software) to the PLC?
We would appreciate your help very much.
Best regards,
Dalibor Muratovic,
UMBRA software
Beograd
we have a customer with an old TMQ TSX 67 40 PLC with the P67 425 processor. The configuration also includes 9 AXIS modules of the type TSX
AXM 162 (single-axis control). The controller was put into operation in 1995/6.
We need, for diagnostic reasons, to upload the program, but don't have either the software or the connection cables (and/or PCI cards)
necessary. Would you be so kind to help us with the following:
1) what is the software needed for uploading and monitoring of the program from this type of PLC (including monitoring of the AXIS modules)?
2) what is the hardware (the cable, and/or the PCI card) for connecting a PC (with the above software) to the PLC?
We would appreciate your help very much.
Best regards,
Dalibor Muratovic,
UMBRA software
Beograd