syswin v 3.4

J

Thread Starter

jameswesleyjones

communication with omron c28k how do i do it from labtop to plc .cable diagrams? in picture form would be great.
 
D

David Wooden

<pre>
You will need a 3G2C7-LK201-EV and a C500-CN221-EU cable configuration.

The pinout is as follows:

25 pin D-Sub 9 pin D-Sub
PLC side PC side
SD 2 -------------------------------------------------- RD 2
RD 3 --------------------------------------------------- SD 3
SG 7 --------------------------------------------------- SG 5
RTS 4 -+
CTS 5 -+
+- DTR 4
+- DSR 5

+- RTS 7
+- CTS 8

-+
-+ : These pins are connected together on the same end of the cabel and are not connected at the other end.

HTH,
David Wooden
Senior Software Engineer, Systems Integration
Automation and Enterprise Solutions Group
TAS Division of Omron Electronics LLC
Office: (847) 884-7034 Extension 432
Fax: (847) 884-9383
E-mail: [email protected]
</pre>
 
E
Correction..... The number should read 3G2C7-LK201-V1. I guess I stayed on the shift key a little too long, producing a "#" instead of a "3" ;oP

-Eric
 
Top