Control.com

Thermocouple setup

Search Forums New Posts
M

Thread Starter

Mike Stevenson

I have a project that will use a minimum of 6 channels of thermocouples. Before I begin I would like to check on the most efficient way to set it up. Is there a user-definable tag available to set up each channel or do you have to do it the hard way, etc.
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
D G. E Exhaust Thermocouple with P/N 328A8483P001 change to P/N 302A4010P002 Sensors & Calibration 5
A K Type Thermocouple probe short circuited with metallic body Sensors & Calibration 5
H Mark IV Thermocouple addition procedure Power Generation 9
S GE Frame 9E Gas Turbine Exhaust Thermocouple TTXD_12 Low Value Power Generation 5
P Type K thermocouple extension cable signal strength at 150M General Communications Chat 1
Similar threads
G. E Exhaust Thermocouple with P/N 328A8483P001 change to P/N 302A4010P002
K Type Thermocouple probe short circuited with metallic body
Mark IV Thermocouple addition procedure
GE Frame 9E Gas Turbine Exhaust Thermocouple TTXD_12 Low Value
Type K thermocouple extension cable signal strength at 150M

You May Also Like

Top