Transfering data from pc to cc100 control using windows XP

J

Thread Starter

John Baron

Please advise on data transfer program to transfer my cnc programs back and forth from PC (windows XP) and cnc lathe (Bosch control--cc100). I was using Pcplus with windows 98 on my old PC.
[email protected]
 
C
> Please advise on data transfer program to transfer my cnc programs back and
> forth from PC (windows XP) and cnc lathe (Bosch control--cc100). I was
>using Pcplus with windows 98 on my old PC.

I can help you with the correct protocol.
 
you can use software called term do you have if you do not have please send me email to send you this software and and use rs232 9 pin with hardware flow control use baud rate 9600 and in bosch side use port 1 and use baud rate 9600

for more accurate details contact me on my email
 
Hello,

I need communicate with a CC120M (for parameters and programs) via RS232, can help me?

Thanks, Patxi.
 
Top