Control

Using a Telemecanique PLC as a Modbus Slave

D

Thread Starter

David

I am trying to get a TSX P57 2634M to be a Modbus slave. The existing master will be comunicating to the PLC through a TSX SCP 111 PCMIA card. I have the card installed and its function set up as 'Modbus JBus Link'. What else do I need to do to get the PLC to act as a modbus slave? What sort of addressing do I need? Are there any function blocks I need to use? etc...
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
B Honeywell PHD RDI connection to ControlLogix's PLC's using factory Talk SE Programmable Logic Controller - PLC 0
K Using peak load to minimise emissions in normal ops (Frame 6s / Mark VI) Power Generation 3
LamijaZ Communication between ABB RTU530 and Siemens 7SJ62 using IEC 60870-5-103 protocol General Automation Chat 0
M Connecting Siemens and Telemecanique PLCs using Modbus TCP/IP Modbus 0
A Creating a Totalizer using Modicon Telemecanique PL7 General Automation Chat 3
Similar threads
Honeywell PHD RDI connection to ControlLogix's PLC's using factory Talk SE
Using peak load to minimise emissions in normal ops (Frame 6s / Mark VI)
Communication between ABB RTU530 and Siemens 7SJ62 using IEC 60870-5-103 protocol
Connecting Siemens and Telemecanique PLCs using Modbus TCP/IP
Creating a Totalizer using Modicon Telemecanique PL7

You May Also Like

Top