Control

Using different USB to RS485 converters

Y

Thread Starter

Yves Régeard

I use 2 kinds of USB to RS485 converters. The 1st one is based with original FT232RL and works well for many days using modbus between a raspberry and a device (Heater system). The 2nd one is based with CH343G and the dozen of first messages are correctly exchanged then some various errors appears(CRC error, ressource unavailable, ...), and the system never re-synchronize the exchanges. The application is the same except the name interface: /dev/ttyUSB0 in the 1st case and /dev/ACMA0 in the 2nd case.
Many thanks
 
S

Swami

I had crazy experiences while working with such USB to serial converters.
Some brands will work only with certain devices.
But finally figured it out that many of the American brand (Like Trendnet TSU9, Triplite) work flawlessly, where as chinese will have poor success rates.
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
B Honeywell PHD RDI connection to ControlLogix's PLC's using factory Talk SE Programmable Logic Controller - PLC 0
K Using peak load to minimise emissions in normal ops (Frame 6s / Mark VI) Power Generation 3
LamijaZ Communication between ABB RTU530 and Siemens 7SJ62 using IEC 60870-5-103 protocol General Automation Chat 0
N Using Modbus to Send Data Across to Two PLCs Belonging to Two Different Networks Modbus 1
C Controlling Different Cookers Using Same HMI Human Machine Interface - HMI 9
Similar threads
Honeywell PHD RDI connection to ControlLogix's PLC's using factory Talk SE
Using peak load to minimise emissions in normal ops (Frame 6s / Mark VI)
Communication between ABB RTU530 and Siemens 7SJ62 using IEC 60870-5-103 protocol
Using Modbus to Send Data Across to Two PLCs Belonging to Two Different Networks
Controlling Different Cookers Using Same HMI

You May Also Like

Top