J
Hi listers,
I would like to connect a very small (and cheap) PLC ( TSX NANO) to a TCP/IP network. This PLC has Modbus protocol (as slave) on board. There are cheap converters (RS485 -> ethernet) and I would like to communicate through the network to the PLC in Modbus (not in modbusTCP). What about time response? Is it working ? Perhaps is it better to work through RS232 in a special protocol where there are no response time constraints.
On the PC side, the converter is considered as a COMx.
thank you for your opinion.
Jeff
SoViLor company
[email protected]
I would like to connect a very small (and cheap) PLC ( TSX NANO) to a TCP/IP network. This PLC has Modbus protocol (as slave) on board. There are cheap converters (RS485 -> ethernet) and I would like to communicate through the network to the PLC in Modbus (not in modbusTCP). What about time response? Is it working ? Perhaps is it better to work through RS232 in a special protocol where there are no response time constraints.
On the PC side, the converter is considered as a COMx.
thank you for your opinion.
Jeff
SoViLor company
[email protected]