Control

Using Pac-Sci 950 with Modicon 984 PLC

K

Thread Starter

Kyle Polster

As of now, I have the Modicon 984 setup as the Modbus master using their XMIT block, but it still will not communicate with the PAc-Sci 950. I am looking for someone who has done this application in the past and could lend me a helping hand. As far as I can see, all of my parameters are correct and I should be able to communicate between the two, but no luck. Maybe there is one little secret that I cannot figure out. If you have any experience with this, any info would be a great help. Thanks.

 
B

Brad Hite

Hello Kyle,

I have completed a couple of projects using the XMIT and the MSTR function blocks to control drive packages. Please feel free to contact me off-list. I may be able to offer some insight.

Bradley G. Hite
Intertech Incorporated
mailto:[email protected]
http://www.myplc.comTeaching Practical Skills for a Technological World
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
B Honeywell PHD RDI connection to ControlLogix's PLC's using factory Talk SE Programmable Logic Controller - PLC 0
K Using peak load to minimise emissions in normal ops (Frame 6s / Mark VI) Power Generation 3
LamijaZ Communication between ABB RTU530 and Siemens 7SJ62 using IEC 60870-5-103 protocol General Automation Chat 0
ducanhasd Control Servo mitsubishi using FB Motion Control 0
G Retrieve engine data via ComAp using Modbus RTU General Communications Chat 0
Similar threads
Honeywell PHD RDI connection to ControlLogix's PLC's using factory Talk SE
Using peak load to minimise emissions in normal ops (Frame 6s / Mark VI)
Communication between ABB RTU530 and Siemens 7SJ62 using IEC 60870-5-103 protocol
Control Servo mitsubishi using FB
Retrieve engine data via ComAp using Modbus RTU

You May Also Like

Top