Control

why am i not able to communicate

P

Thread Starter

paru

we have two plcs and three hmi connected through ethernet and commuicating. Few days back we had to changed the old IP adresses of all nodes due to some problem. After changing IP one PLC is communicating with HMI but from other PLc i am not getting any data.

I changed IP address of PLC, HMI and in WinCC also.

How should i check and solve this problem?
 
C

CH

For the device that is not communicating, run it through a HUB, then from the HUB to your network. Now connect a PC in to the HUB, and capture the packets with WireShark. You should be able to ascertain why this device isn't communicating (cannot open connection, not getting a response, etc).

CH
 
R

Roy Matson

Perhaps the new address didn't take properly, try pinging the old address/new address with a PC and crossover cable

Roy
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
umair-iftikhar PLC To communicate with MQTT Azure/AWS Cloud - I check Micro820 Programmable Logic Controller - PLC 0
A A master system missing, Three PLCs communicate with each other through ethernet network, is that a DCS Distributed Control Systems - DCS 2
J Which able to use for RS-485 connection? General Communications Chat 4
K Not Able to Configure ABB DMC tzidc 120 General Communications Chat 0
V MARK V IDOS not able to edit rungs and prom files Power Generation 24
Similar threads
PLC To communicate with MQTT Azure/AWS Cloud - I check Micro820
A master system missing, Three PLCs communicate with each other through ethernet network, is that a DCS
Which able to use for RS-485 connection?
Not Able to Configure ABB DMC tzidc 120
MARK V IDOS not able to edit rungs and prom files

You May Also Like

Top