D
Dear list
I wonder if someone could help me please.
I've been happily using RSLinx comms on Win98 but I've just put a different hard disk in my laptop running NT4. I want to use an RS232 DF1 driver but when I try to add it in Linx I get the message
"RSLinx failed to configure the COM port (the COM port may already be in use)". I suspect this is due to my lack of knowledge of NT rather than Linx but I don't believe I'm using COM1 for
anything else! I know the COM port itself is ok because it works fine with Win98. Thanks in advance for your help.
Regards David
I wonder if someone could help me please.
I've been happily using RSLinx comms on Win98 but I've just put a different hard disk in my laptop running NT4. I want to use an RS232 DF1 driver but when I try to add it in Linx I get the message
"RSLinx failed to configure the COM port (the COM port may already be in use)". I suspect this is due to my lack of knowledge of NT rather than Linx but I don't believe I'm using COM1 for
anything else! I know the COM port itself is ok because it works fine with Win98. Thanks in advance for your help.
Regards David