P
Well, the summary quite says it all. Although I installed the Applicom driver in WizPLC, I am unable to use IEC-addressing (%IX...) to access my Applicom DPIO-Board. I WAS able to define the I/Os in WizCon, but when I use the WizCon gates in WizPLC, I get a terribly high response time.
I was told that this might be due to the fact that the WizCon driver is very slow and the solution would be to define the tags directly in WizPLC - but so far I was unsuccessful in doing so.
I would appreciate if anyone could give me a hint what to try or what I might be doing wrong (as I guess the error is on my side)
Yours,
Philipp
I was told that this might be due to the fact that the WizCon driver is very slow and the solution would be to define the tags directly in WizPLC - but so far I was unsuccessful in doing so.
I would appreciate if anyone could give me a hint what to try or what I might be doing wrong (as I guess the error is on my side)
Yours,
Philipp
