Control

xxmit initialization

A

Thread Starter

Anonymous

how can i know the specified area or device that the output of some block go??

e.g ADD_INT block the output of it is 4:00102
this address 4:00102 how can i know where is it or what it means in plc?
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
H XXMIT BLOCK with Ametek Annunicator General Communications Chat 1
C Modbus Comm's - Quantum to Momentum - Time Settings - XXMIT block Modbus 1
C Modbus - XXMIT Block - Parameters - Active and Done Modbus 0
C XXMIT block - Modbus - PLC to PLC - Master to 1 Salve Modbus 0
C Concept v2.2 - Using XXMIT Block - Is it possible? Programmable Logic Controller - PLC 2
Similar threads
XXMIT BLOCK with Ametek Annunicator
Modbus Comm's - Quantum to Momentum - Time Settings - XXMIT block
Modbus - XXMIT Block - Parameters - Active and Done
XXMIT block - Modbus - PLC to PLC - Master to 1 Salve
Concept v2.2 - Using XXMIT Block - Is it possible?

You May Also Like

Top