Control

Yokogawa and Siemens Profibus Problem

H

Thread Starter

Hamid Ali

Hi,

I'm facing a problem in yokogawa ALP111 (Master address 02) profibus coomunication with seimens 315-2DP-AF03 (Slave address 03). I configure all stuff according to manual but when i call the PLC tags in yokogawa i get zero value. i have also the snaps of DCS & PLC configuration for profibus.

can somebody experience this before.

Regards
Hamid Ali.
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
L Siemens S5 - Yokogawa Centum Communication General Communications Chat 0
S Yokogawa CS3000 DCS to Siemens S7-400 PLC Modbus DO Communication Distributed Control Systems - DCS 1
J Comunication Problems on Profibus Yokogawa and Siemens General Automation Chat 7
Z Comaprison of Siemens and Yokogawa control Systems General Automation Chat 0
J Combination Yokogawa and Siemens General Automation Chat 2
Similar threads
Siemens S5 - Yokogawa Centum Communication
Yokogawa CS3000 DCS to Siemens S7-400 PLC Modbus DO Communication
Comunication Problems on Profibus Yokogawa and Siemens
Comaprison of Siemens and Yokogawa control Systems
Combination Yokogawa and Siemens

You May Also Like

Top