Control

Yokogawa Centum CS 3000 FCS Vnet Loading

M

Thread Starter

Maher Hussain

We have Yokogawa Centum CS 3000 DCS with 8 Vnet/IP domains (bus 1/2) and more than 50 FCS.

I'm looking for a solution to monitor the performance of FCS and Vnet/IP in terms of loading and Alarms.

Is there a way to historise FCS and Vnet/IP loading and provide alarm when load reaches to some setpoint.

In Foxboro DCS it is possible since the Nodebus and CP loads are objects.
 
L

Lubo

FCS load can be decoded from system switches. See manual for details. Vnet load can be displayed on HIS by command line utility. Check CS3000\net directory.
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
P Calculation of Totalizers in Yokogawa Centum 3000 General Software Chat 4
D Migrating Yokogawa Centum 3000 to Centum VP Process Control 2
S programming dcs centum 3000 yokogawa Distributed Control Systems - DCS 0
A What is the advantage of the Yokogawa Centum CS 3000 over the Centum CS General Automation Chat 2
D Installation guide for ACM 12 card in Yokogawa centum cs 3000 DCS Distributed Control Systems - DCS 3
Similar threads
Calculation of Totalizers in Yokogawa Centum 3000
Migrating Yokogawa Centum 3000 to Centum VP
programming dcs centum 3000 yokogawa
What is the advantage of the Yokogawa Centum CS 3000 over the Centum CS
Installation guide for ACM 12 card in Yokogawa centum cs 3000 DCS

You May Also Like

Top