M
I want to start and stop the motor by Profibus communication from
DCS (ALP111 Yokogawa card) to MICROMASTER420 Siemens and acknowledge the fault of drive MICROMASTER420 from DCS. How can I config the
ALP111 (communication I/O Builder) and MICROMASTER420 parameters?
Please help me.
EMAIL: [email protected]
DCS (ALP111 Yokogawa card) to MICROMASTER420 Siemens and acknowledge the fault of drive MICROMASTER420 from DCS. How can I config the
ALP111 (communication I/O Builder) and MICROMASTER420 parameters?
Please help me.
EMAIL: [email protected]