sirs,
I am an Instrumentation engineer(fresher E&I).
Iam doing a project for one of my friends. PLC controlled reclaimer for power prod. application.
I decided to do a prototype and i am thinking to
control it using ladder diagram in plc. I have a doubt that a signal from the PLC KIT can control the different motor in the prototype (Is the signal is sufficient to control it? and mainly I reqire the vendor of PLC kit with contact address/Email. I hope for a positive reply from you.

thank you,
saravana babu

 

PLCs can control motors by operating a motor starter of contactor. The website for control information is http://www.modicon.com for PLC information and http://www.squared.com for the other control components and the motor starter for handling the power to the motor.

 

Dear Saravanababu,

If your project is non-commercial and it is used only for a final year BE degree programme then I am ready to help you .You can contact me at [email protected]

Bye,

Jayaharan C J

 

I had same type of project. We used PLC to start-stop the motor (very small one) I can send you this PLC used in project. Plz contact me at [email protected] for further details.
-yogesh