Control

Alarm Message Tone Change in Yokogawa Centum CS DCS

M

Thread Starter

Mihir Ramkrishna

I want to change the alarm tone of tag. I do not want to use the hi priority alarm since it repeats. I want (beee, beee or paaa paaa etc. sounds to appear which should be different from the other sounds on this tag.
 
B

BobB

Don't know the software but most SCADA systems can run a sound file from a tag with a little bit of code.
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
T MK5 Intermittent C Processor LCC alarm message "Fail Rom - Main 3" Power Generation 5
T Replaced VSVO card on Simplex MK6 generates alarm message after config download Power Generation 6
T Mk5 IOCFG Editor Opening with Alarm Message Power Generation 5
M What is the Cimplicity Alarm Message on a High-High Vibration Trip? Power Generation 2
F MARK V alarm message Power Generation 4
Similar threads
MK5 Intermittent C Processor LCC alarm message "Fail Rom - Main 3"
Replaced VSVO card on Simplex MK6 generates alarm message after config download
Mk5 IOCFG Editor Opening with Alarm Message
What is the Cimplicity Alarm Message on a High-High Vibration Trip?
MARK V alarm message

You May Also Like

Top