Iltis on QNX

D

Thread Starter

dodo1370

I would like to find out if it's possible to run a Iltis version 1.0 application (SCADA application) designed on the QNX 3.1 operating system to a new QNX version as 4.xx or higher.
The ILTIS application run perfect on QNX 3.1 but the company decided to change the O.S.
 
Z

Zeljko Fucek

QNX 3.1 never existed - there was QNX 2, QNX 4.x, and now QNX 6.x. I don't believe that you can run QNX binaries on Windows platform. For more information you may see http://www.ist.ch

Good luck,
Zeljko
 
A

Armin Steinhoff

QNX 3.1 is the protected mode version of QNX 2.1 ... but QNX 2.1 is more than 20 years old and it is completely incompatible with QNX4, which is more than 10 years old :)

No chance to use the QNX 3.1 version of ILTIS on QNX4.

Best Regards

Armin Steinhoff
 
Not true that QNX 3.x did not exist. Qnx 3.1 was simply the networked version of QNX 2.x. QNX 2.x/3.x binaries will not run under 4.x or later. Al Buxton
 
Top