Honeywell TK-FTEB01 C200 Card

R

Thread Starter

RThomas

I have a new FTE Card (Honeywell TK-FTEB01 Rev C) Bridge card. When placed in the Honeywell C200 controller all tests pass normally until it reaches the boot process. The OK LED blinks green while scrolling through the boot test, then the OK LED goes steady red. (Fatal Error) What could the cause be? All else is good.

This occurs even when it is the only card in the rack. This Occurred right out of the box.

Naturally it is out of warranty.

Thanks
RThomas
 
Top