Today is...
Thursday, July 18, 2019
Welcome to Control.com, the global online
community of automation professionals.
Featured Video...
Featured Video
A demonstration of EtherCAT control of linear motors using the CTC EtherCAT master.
Our Advertisers
Help keep our servers running...
Patronize our advertisers!
Visit our Post Archive
Baseload Programing for Easygen 3200
Genset required to run in Base-load mode, but tries to assume over 600kw
By Hugh Griffith on 26 December, 2018 - 9:52 pm

3500 Caterpillar Genset equipped with Easygen 3200 is required to run in Base-load mode. After synchronizing genset to bus, the genset tries to assume over 600kw then instead of the 200kw baseload reference programmed.

Can you advise?
Thanks in advance for your support
hughgriffith3@gmail.com