Hello,
In my process plant, we are using ABB Freelance 900 DCS (2013 SP1). Our Engineering Workstation (PC) hard disk crashed after that we replaced the hard disk (HDD to SSD) and installed Control Builder F software. When we open our project backup from another drive and compile it's showing an error in DigiVis "D-PS resource PS_R must be correct".
It will be very helpful if you guide me on how to solve this error.
In my process plant, we are using ABB Freelance 900 DCS (2013 SP1). Our Engineering Workstation (PC) hard disk crashed after that we replaced the hard disk (HDD to SSD) and installed Control Builder F software. When we open our project backup from another drive and compile it's showing an error in DigiVis "D-PS resource PS_R must be correct".
It will be very helpful if you guide me on how to solve this error.
