Control

Configuring Server- Client Simulation in WINCC

S

Thread Starter

srinivasan

Hi everyone,

I would like to configure server/client in wincc professional (TIA V13) through simulation. is there possible to do with the simulation? if it is possible what is the procedure to do that? i created server/client and set two systems IP address. i don't know further steps, so help me guyz.


 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
Ankur1007 Configuring Analog I/O board and I/O packs of Mark Vie control system Power Generation 2
S Configuring SDB Utility General Automation Chat 0
L Configuring OPC LINK to connect to Matrikon OPC Server for Bailey Open Platform Communications (OPC) 0
F configuring LINOPC Server Open Platform Communications (OPC) 1
W Configuring 2 NIC cards on NT4 Server Networking 4
Similar threads
Configuring Analog I/O board and I/O packs of Mark Vie control system
Configuring SDB Utility
Configuring OPC LINK to connect to Matrikon OPC Server for Bailey
configuring LINOPC Server
Configuring 2 NIC cards on NT4 Server

You May Also Like

Top