Control

Cards of GE Speedtronic Mark V

D

Thread Starter

Dzmitry

Hello!

In Mark V there was card DS200TCDAG1B. Its replacement was required. Have sent card DS200TCDAH1B. From an old card we have displaced ROM on a new card, have checked up jumpers. After card installation in Mark V, the controller is loaded, but there are diagnostic messages: 0800, 0801, 0929, 0930, 0931, 0932.

Tell, please! Do these cards interchangeable? What distinctions in them? Where is problem?

Best regards!
[email protected]
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
ali.mok66 Can someone explain to me what the following symbols mean TB_PT_1 & TB_PT_2 for PDIA Card (DCS Cards)? General Automation Chat 1
R How can I do the configuration of I/O cards with the xhw file in EcoStruxre Control Expert? Programmable Logic Controller - PLC 0
D Recent Speedtronic Mark V Cards Power Generation 1
D Potential Risk for Speedtronic Cards Power Generation 3
I Mark-V speedtronic cards General Automation Chat 0
Similar threads
Can someone explain to me what the following symbols mean TB_PT_1 & TB_PT_2 for PDIA Card (DCS Cards)?
How can I do the configuration of I/O cards with the xhw file in EcoStruxre Control Expert?
Recent Speedtronic Mark V Cards
Potential Risk for Speedtronic Cards
Mark-V speedtronic cards

You May Also Like

Top