Control

Using MAXDNA with Modbus interface

A

Thread Starter

anonymous

I was wondering how to get the IP address and the port address of the DCS master as the DCS slave requires the same for establishing the communication with the Metso automation system.
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
B Honeywell PHD RDI connection to ControlLogix's PLC's using factory Talk SE Programmable Logic Controller - PLC 0
K Using peak load to minimise emissions in normal ops (Frame 6s / Mark VI) Power Generation 3
LamijaZ Communication between ABB RTU530 and Siemens 7SJ62 using IEC 60870-5-103 protocol General Automation Chat 0
ducanhasd Control Servo mitsubishi using FB Motion Control 0
G Retrieve engine data via ComAp using Modbus RTU General Communications Chat 0
Similar threads
Honeywell PHD RDI connection to ControlLogix's PLC's using factory Talk SE
Using peak load to minimise emissions in normal ops (Frame 6s / Mark VI)
Communication between ABB RTU530 and Siemens 7SJ62 using IEC 60870-5-103 protocol
Control Servo mitsubishi using FB
Retrieve engine data via ComAp using Modbus RTU

You May Also Like

Top