Today is...
Sunday, September 24, 2017
Welcome to Control.com, the global online
community of automation professionals.
Featured Video...
Featured Video
A demonstration of EtherCAT control of linear motors using the CTC EtherCAT master.
Our Advertisers
Help keep our servers running...
Patronize our advertisers!
Visit our Post Archive
Schneider XBTZG915 cable pinout
Creating a cable for telemecanique XBTZG915

I would like to back up the application of telemecanique XBTG2110 by using Vijeodesigner which I do not have the source of application nor the cable. wanted to create the cable by my self. any help will be appreciated.

>I would like to back up the application of telemecanique
>XBTG2110 by using Vijeodesigner which I do not have the
>source of application nor the cable. wanted to create the
>cable by my self. any help will be appreciated.

This is an old question, but many people can refer to the info later.

VJD application cannot be retrieved from the panel unless someone put a application backup on it. Usually no one does.

The XBTZG915 cable is a 232 cable pinout is on Schenider FAQ page. You can also contact them for it - it is legacy they probably will volunteer some advice on how to proceed.