Recent content by Alejandro

Search Forums New Posts
  1. A

    No Alarmas on MARk VI hmi

    Hi I dont have any alarms on the operator screen or the explorer page... When I check the TCI setup I get the message in the picture.. Does anybody have any ideas Thanks
  2. A

    Diagnostic led's on MARK V

    Thank you for the information. We some times get a trip with the alarm of "communication loss R and C processors" I will upload a photo later. And the leds are in the state of the picture I uploaded erlier. When its normal only the first led on the left side is flashing. We apply some...
  3. A

    Diagnostic led's on MARK V

    Hi, does anybody have any documentation or manuals on what's the information display on the row of leds on the MARK V processors. Thank you
  4. A

    No alarms showing on HMI. Mark 6

    After checking everything we did a reset on each one of the controlers and we finaly got alarms on the steam turbine Thanks for the support specialy to the great WTF Have a great weekend everybody
  5. A

    No alarms showing on HMI. Mark 6

    Hi The problem started when we disconected the two switches you mention, on an outage, to clean them. There are two hmi's and one engineering station I check the settings on the alarm window of the operator and engineering HMI's. They are set to get alarms from the steam turbine and the bop...
  6. A

    No alarms showing on HMI. Mark 6

    Wierd thing is we have two steam turbines on separate tmr mark VI systems and the problem is on the two systems. Same thing, no alarms just in the steam turbine... The only thing they share is a pi historian.
  7. A

    No alarms showing on HMI. Mark 6

  8. A

    No alarms showing on HMI. Mark 6

    On the workstation and engineering station only alarms for BOP show. I can simulate alarm conditions on the steam turbine but they dont show up on the display on the cimplicity alam viewer.
  9. A

    No alarms showing on HMI. Mark 6

    Hi Yes... Mark VI We use the same HMI for the steam turbine and the bop. But only the BOP alarms are showing We have reboot the workstations but that did not solve the problem The steam turbine is a TMR service... We have not rebooted the controlers I will try to start and stop the services...
  10. A

    No alarms showing on HMI. Mark 6

    Has anyone had the problem of the alarms on the HMI stop showing up on your mark 6? We have a mark 6 for the BOP and one for the Steam turbine but only the turbine ones stop showing up During the outage we disconect the switches to clean them and since then this happend Thanks
See more
Top