Recent content by Controlmathis

  1. C

    Tsx Nano program conversion

    Hi ; The TSX NANO is a very old and discontnued PLC. And there is no converter from a PL7 07 to the TSX micro or M340 platform. I suggest you to rewrite the program. Thank you.
  2. C

    Motor overheating with correct VFD parameters

    Hello; At what speed do you want to run your motor compared to the rated speed? I suggest you put a forced ventilation on your motor, this will cool your motor properly even at low speeds,
  3. C

    Unimat UH404E HMI with Siemens Logo 8

    Hello Samir99; Since your HMI communicates in Modbus, your logo should support this protocol. What is the firmware version of the logo you are using? I see on the picture that the logo reference ends with 0BA8. With a firmware FS04 or higher you will have the modbus TCP otherwise your logo will...
  4. C

    Pressure Transmitter 4~20mA and 0-10V signals

    Well noted! Thank you for these precisions. I have some questions: - Would you still recommend the 4 20 mA current loop if there are several signals to follow? - Are there any disadvantages with the 4 20mA current loop? Thank you!
  5. C

    Pressure Transmitter 4~20mA and 0-10V signals

    Yes, with a 4-20 mA current signal, you will have less loss than with a 0-10 V voltage signal. However, if the distance becomes really long (more than 30m), it would be wise to consider a solution by IOLink for a greater precision of the signal measurement.
  6. C

    Quel protocole de communication

    Bonjour @Liad , le TSX Premium possède de base le Modbus . Vous pourrez donc utiliser le Modbus TCP. Puis je savoir quel est le processeur TSX premium que vous utilisez? Merci.
  7. C

    Programing cable for GE Versamax IC200CPU001

    You can go with this : USB-IC200CBL500A. You will find it on ebay.com
  8. C

    Selection of PLC hardware

    Hello, I would like to have some precisions: - What brand of PLC is currently installed ? - Do you want to keep the same brand? Thank you!
See more
Top