Recent content by cotybrooks

Search Forums New Posts
  1. C

    Wiring safety edges into existing circuit.

    Hello all, I need some help wiring some safety edges into an existing safety circuit. its a 2 wire edge that were adding to a roll up door to create an estop condition if pressed. I am putting 3 of these on both the front door and back door of the machine. I have been informed by the...
  2. C

    Getting an intermittent 24vdc safety power fault. Help finding problem source

    So I ended up finding a bad ib8s safety module. Never would’ve thought that was the cause. Swapped the module with another ib8s next to it and started seeing new faults associated with that terminal.
  3. C

    Getting an intermittent 24vdc safety power fault. Help finding problem source

    Hello all, I have a coater machine that is throwing an intermittent dc safety power fault. Everytime it happens it throws that fault along with a handful of faults for safety devices. the machine can immediately be reset and ran again. Sounds like either a loose wire somewhere or a voltage drop...
  4. C

    Catbridge unwinder chucks not moving

    Hello all, I am a new controls tech just getting started and i have an issue that maybe you guys can point me in the right direction with. So we have a slitter machine and an unwinder that moves using a hydraulic motor. there are various control switches that operate the chucks differently...
See more
Top