Dears,
We are operating GE Frame 9E gas turbine with Mark VIE control system. This unit is DLN 1.0 i would like to ask a question related to Jacking oil pump. can we start and stop 88QB pump online while unit is running on Base load with Design RPM. To measure some electrical data like...
Hi Dear,
We have 4 Gas turbine frame 9e.03 can any body tell me while we are using bearing lift oil pump. Pump discharge is 240Bar to Generator Bearing how much shaft is lift through this pressure. means to say who much clearance is around bearing and shaft to give an oil seal between bearing...
Dear,
I want to share an issue/observation last week stop one gas turbine frame 9e.03 when it reached turning gear Bearing lift pump comes in operation at 128rpm. Turning normally engage at 130 rpm till 15 mint turning gear was running normal and torque angle was 43 degree
suddenly Bearing lift...
hi
i want to ask a question about Gas turbine Frame 9e DLN 2.1. we are operating machine on Gas fuel it has three manifold. like to say 3 GCV and 1 SRV
1. primary manifold
2.secondary manifold
3.transfer manifold
can any one tell me what is specific load for using these three manifold when...