Recent content by Khalil Gaser Reda

Thanks for sharing your thought. Here's the story: we're moving right along, and the big thing is learning to adapt. These new guys are soaking up tons of info "usually so easy to get" , but it's all kind of thrown at them. as technical trainer my challenge is to guide how to use the...

Hey there! We've all been newbies at something, right? I tried to give him some pointers, showing him how to ask questions that'd get good answers from pros like you. AI is everywhere these days; it's used all the time, and teaching others how to use it is pretty cool. Good day :)

1st of all , the question is so poor , looks like open end question to ask proper question I advise us to you the 5W and H (what, when, when, where, who, why and How) , which give some detailed about the incident so we can perfom detailed RCA, any how to help you understanding what happened ...

No worries Bro , Best of luck.

Regarding Prolonged TG Operation – Potential Impacts on Generator For F-class (e.g., 7FA.05) and H-class (e.g., 9HA) machines, extended TG running beyond OEM recommendations can cause: a. Bearing & Seal Wear Journal and thrust bearings in the generator are still carrying rotor weight...

This was side question by the poster , try to educate yourself using good wording.

In a combined GT generator system (Frame 6, 7, 9), the generator’s excitation system regulates terminal voltage and reactive power (Vars). Control modes generally available: 1. Voltage Control Mode (Automatic Voltage Regulator – AVR) → Keeps generator terminal voltage constant. 2. Power Factor...

I am Not sure if we have Inlet Bleed heat valve or Not? @ shubham07377

The situation: A GE 9E gas turbine recently had its rotor replaced in February 2024. Since then, the turbine has experienced abnormal load ramp-up during startups, with sudden increases followed by a drop to zero before manual load adjustment. Three desynchronizations from the grid occurred due...