Recent content by red

hi all flow computer has 2 ports Ethernet when i disconnect them the problem is disappeared from two days i will check again when i reconnect them an explanation

thank you a lot i will write if there is any progress

لإhank you for your interest i found some thing :the value of this spike is always 4,294,967,296 pulses and this equal to 2^32 and yes this spike is over range so i found some thing about bad pulses or bad frequency and cut off...

are you advise to put ferrite on flow computer data cables like these

There is no point in checking any piece Because they are all working normally Only in a split second does this jump occur and return to normal operation Imagine that the reading yesterday was 283,500 cubic meters per day, and this means that the jump occurred 4 times (70,000 * 4) = 280000 and...

thank you David for replay.. there is no failure messages or codes just high pulses appeared in split second and every thing else is OK. note some times that happens even there is no flow ( Flow rate is zero) but i found some thing this high pulses is always same value. so if i remove it by...