Recent content by RizerGLI

Search Forums New Posts
  1. R

    GE Mark VIe - Trying to change a TMR setup from a 0-5VDC to a 4-20mA transmitter..

    Correct, it was originally a 4-wire 0-5DC setup but quickly learning this might not work out trying to split the signal to 3 processors like it was setup with the 0-5vdc transmitter.
  2. R

    GE Mark VIe - Trying to change a TMR setup from a 0-5VDC to a 4-20mA transmitter..

    Thank you everyone for the replies. I didn’t get a chance to see these till I got home but I did have some pictures saved that might assist. With the 0-5 setup, wires were landed on spot 3 and 4 (on right under words Note 2) and the jumpers were installed on spots 2&3 for both rows (second...
  3. R

    GE Mark VIe - Trying to change a TMR setup from a 0-5VDC to a 4-20mA transmitter..

    Thank you for the response! You are correct, it is for the CPD setup. As it currently stands, i have the single xtmr weird up running on 4-20 hart. (it was previously a 0-5V and setup externally powered). I relocated the wires on the TB so its 24V powered and running on the return leg.(Including...
  4. R

    GE Mark VIe - Trying to change a TMR setup from a 0-5VDC to a 4-20mA transmitter..

    Hello all, looking for some assistance. Im trying to replace some old rosemount transmitters with updated ones and in this current case, its a externally powered not smart 0-5VDC, setup as TMR. After i hook up the new rosemount running hart 4-20ma, i can get a good reading in toolbox once...
See more
Top