Recent content by Touggourt

  1. T

    Servo valve Moog installation

    Thank you WTF for these informations. Best regards
  2. T

    Servo valve Moog installation

    Good day WTF, The manifold block is made of steel Currently we do not have another manifold block but we plan to request one from the manufacturer as part of the punch list The surface of the manifold block looks perfect We replaced the servo with another but it didn’t solve the problem GE...
  3. T

    Servo valve Moog installation

    Thank you very much WTF for your answer concerning the o-ring it was there but as there are even leaks, the servo valve was installed on the SRV valve and works perfectly but with oil leaks. We wanted to know if it is necessary to replace the support with another with 4 holes or even with 3...
  4. T

    Servo valve Moog installation

    Hello everybody, I need some information about, moog installation, since commissioning our frame 9 turbo generator set with mark6e TMR has had an oil leak at the servo valve (Moog whose photo is attached with its support) when dismounting the servo valve we noticed that the support of this servo...
  5. T

    Generator Circuit Breaker low SF6 pressure in close position

    In general a generator is connected to a step-up transformer via an 11.5Kv circuit breaker before being connected to the grid, and the transformer is connected to the grid via a 30Kv or 220Kv circuit breaker or other, in the event of a drop in SF6 pressure the circuit breaker 30 or 220 Kv can be...
  6. T

    Adding an RTD card TBCB

    Hello everyone, We migrated from markv to markvie for our turbogenerators, in the old configuration the generator and the transformers are protected by a separate panel (02 thermometric stations) following the faults of the latter we have integrated the RTDs of a single temperature station to...
See more
Top