Control

Sending emails using SEND_REQ Unity Pro software v 2.3

  • Thread starter Automation engineer
  • Start date
A

Thread Starter

Automation engineer

I would like a piece of program to send an email through through the integrated ethernet port of a Unity Premium software v2.3.

I tried with SEND_REQ function, the request was sent to the ethernet module but resulted in a Fail error #FD, could you please help determine the correct settings of the SEND_REQ FB.
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
I Use of Intrinsically Safe Wiring for Sending a Non-Intrinsically Safe Signal between Two Safe Areas Electrical Engineering 0
A Sending Serial NMEA RS485 packet from ABB HMI CP620 Human Machine Interface - HMI 0
H sending arrays with modbus TCP - wrong values received in slave PLC General Communications Chat 1
Mpanahipour Sending Temp. setpoint via BACnet to a boiler Programmable Logic Controller - PLC 2
A Sending out value from memory based on encoder value Programmable Logic Controller - PLC 0
Similar threads
Use of Intrinsically Safe Wiring for Sending a Non-Intrinsically Safe Signal between Two Safe Areas
Sending Serial NMEA RS485 packet from ABB HMI CP620
sending arrays with modbus TCP - wrong values received in slave PLC
Sending Temp. setpoint via BACnet to a boiler
Sending out value from memory based on encoder value

You May Also Like

Top