G
Our Mark V rev B contains the optional TCCB card in location 3. I was hoping to add three additional analog inputs by modifying the io configuration, io.asg and longname.dat and setting BJ1, BJ2 and BJ3 jumpers on the TBCB board (using C_MAI_15, 16 and 17).
The iocfg_c.api was downloaded to <C> only and <C> core was rebooted after enabling the i/o configuration and setting the ranges with the appropriate scaling. After adding the points in Cimplicity and graphics, the HMI was rebooted. There is no logic associated as this is for informational purposes only (ie cimplicity graphics data).
I have power for the transmitters but the Mark V is not indicating the ma return as seen in the diagnostic counters and the points table in Cimplicity. I've done this same thing for two transmitters on the CTBA card with no issues.
Technically I was adding five transmitters but it is these three that have not been successful. I suspect there is something I am missing for the optional hardware. Maybe something to enable its use?
I would appreciate any insight anyone could offer.
Regards,
Jack
The iocfg_c.api was downloaded to <C> only and <C> core was rebooted after enabling the i/o configuration and setting the ranges with the appropriate scaling. After adding the points in Cimplicity and graphics, the HMI was rebooted. There is no logic associated as this is for informational purposes only (ie cimplicity graphics data).
I have power for the transmitters but the Mark V is not indicating the ma return as seen in the diagnostic counters and the points table in Cimplicity. I've done this same thing for two transmitters on the CTBA card with no issues.
Technically I was adding five transmitters but it is these three that have not been successful. I suspect there is something I am missing for the optional hardware. Maybe something to enable its use?
I would appreciate any insight anyone could offer.
Regards,
Jack