Recent content by MS6001B

  1. M

    GE Speedtronic Mark IV Control-IBH Control Valve Command.

    Hello, we have a machine 6B (MS6001B), there is an IBH hot air extraction system, a pneumatic hot air extraction valve VA20 is installed in the project, it should open when de-icing, compressor protection. Is it possible to open this valve completely, on a working machine in the base load? You...
  2. M

    Diagnostic signal controller MARK-VI ALARM XMIT SUSPEND

    Hi, we are waiting for a scheduled shutdown to properly switch the controllers in turn.
  3. M

    Diagnostic signal controller MARK-VI ALARM XMIT SUSPEND

    Thank you all very much for your help, we have checked all the necessary actions that you wrote. There is only one effective way left, it is correct to reboot the R/S/T controllers in turn, and make a smooth reset. In the instructions GEH-6421, Vol. II, there is only a description of the alarm...
  4. M

    Diagnostic signal controller MARK-VI ALARM XMIT SUSPEND

    Let's check all the Ethernet network connections then.
  5. M

    Diagnostic signal controller MARK-VI ALARM XMIT SUSPEND

    There is no such signal with ID=0 in the database, all signals start with ID=1
  6. M

    Diagnostic signal controller MARK-VI ALARM XMIT SUSPEND

    Checked all L3DIAG signals, all signals with output bit = 0.
  7. M

    Diagnostic signal controller MARK-VI ALARM XMIT SUSPEND

    In the code of the instrumental application using ControlST toolbox, it is not possible to find where this signal is formed, because there is only its description in the form of words.We need its code in the format, for example, like this L4T or, for example, L39VT_ALM. I'm typing a search in...
  8. M

    Diagnostic signal controller MARK-VI ALARM XMIT SUSPEND

    Sorry PUB is a wrong translation, it turned out funny) It's like I wrote a guide from a beer bar).In fact, there are all the manuals from GE, but there are no specific descriptions on this alarm.
  9. M

    Diagnostic signal controller MARK-VI ALARM XMIT SUSPEND

    We have 3 MARK-VI controllers at the same time R/S/T/. Yes, we have a guide from the PUB, but on all stages of verification and error codes, as well as on the presence of LEDs on the front of the error controllers and the causes of the alarm are undetected. There is only this alarm...
  10. M

    Diagnostic signal controller MARK-VI ALARM XMIT SUSPEND

    In a simple way, is it a failure of one of the processor core of the controller?
  11. M

    Diagnostic signal controller MARK-VI ALARM XMIT SUSPEND

    Помогите пожалуйста, появился сигнал ALARM MET SUSPEND . ПРОЦЕССОР ПЕРЕКЛЮЧЕН. Система управления MARK VI (R/S/T), контроллеры UCVG.
See more
Top